How do you make layers stop?

Radishl · Postby **Radishl** » Fri Aug 15, 2014 5:47 pm

How does one make a layer in the editor stop after they are moving.

I want to make a hammer that falls down, comes back up and then falls down again after a couple of seconds.

Like this

Smash - comeback up - wait - smash - come back ect ect

I want the wait event to make the layer stop moving, then the smash event makes it fall down ect ect.

Postby **Valentine** » Fri Aug 15, 2014 5:49 pm

you have to set it's moving speed to 0 (and choose the layer obvs)

Radishl · Postby **Radishl** » Fri Aug 15, 2014 6:08 pm

Little Boo wrote:you have to set it's moving speed to 0 (and choose the layer obvs)

Oh alright I got the thing to stop but, the smashing speed and the moving back speed becomes desynced and they start moving further than they are sopposed to move.

Help me make this smashing machine..

Superiorstar · Postby **Superiorstar** » Fri Aug 15, 2014 7:27 pm

Radishl wrote:
Little Boo wrote:you have to set it's moving speed to 0 (and choose the layer obvs)
Oh alright I got the thing to stop but, the smashing speed and the moving back speed becomes desynced and they start moving further than they are sopposed to move.

Help me make this smashing machine..

Sorry, Its impossible, It took me 3 HOURS just to learn that.

Radishl · Postby **Radishl** » Fri Aug 15, 2014 7:39 pm

Superiorstar wrote: Sorry, Its impossible, It took me 3 HOURS just to learn that.

No its not, I just found out by looking at a dungeon from the invasion.

Heres how to do it

Make 4 events, Smash up , Smash wait, Smash down and smash wait 2
Make the smash up event go first and make it auto start. Select the layer you want when you want it to move, and put -1.048 something like that in the layer speed.. Then make it go up for like 2.7 secs depending on how long u want it to recoil before it waits and then Smashes. Then make it trigger Smash wait. After ur done making it trigger smash wait, make the layer you selected on smash wait to speed 0. Then after ur done with that you add however secs u want before the layer SMASHES down. Then make smash wait trigger Smash down aka SMASH. And on that layer you select the speed of how fast the layer smashes on you ( I personally choose 4 ) And then make it however seconds it takes to reach the floor. If its super close make it like 0.4 secs. It all depends on where the layer is. Then make smash down trigger smash wait 2 and select smash wait 2.
Now click smash wait 2 and repeat the same steps for smash wait. And then make it trigger smash up. Make sure that smash wait 2 and smash wait has the same seconds before trigger.

And wallah you have a smashing thing.
And if you dont understand what Im saying you can go to the invasion2 files, click dungeon 1 and go to section two. And then look at the smashing thing thats on that level.

Lock pls