I am having trouble with warp pipe issues

[SuperFoxDragon]

Hello, it is me again.
I have just ran into an issue with the warp pipes on section 4.
You see I have 2 warp pipes an invisible one and a visible one. The invisible one goes from 3 to 4 sections.

I want the visible pipe at the end of section 4 to warp to section 6 but every time I playtest the level it gets rid of my warp.
Is they something that I am doing wrong!?
Can anyone please help me with this problem?

Thank you.

[Cedur]

Nothing can be seen at all because you're not posting any screenshot.

Sounds like you made a mistake on implementing the respective layers and events.

[SuperFoxDragon]

Sorry, I forgot

[Emral]

1) Did you save when testing?
2) Does SMBX have write-permissions for the folder which the level file is located in?

If the answers to both of these are "yes" then I can't really give much advice other than "don't use the legacy editor it's really broken and buggy", sorry.

(*) Placing the warp should best be done at the bottom edge of the pipe, to make sure characters stay on the ground.

[SuperFoxDragon]

Hello, it is me again.
I have just ran into an issue with the warp pipes on section 4.
You see I have 2 warp pipes an invisible one and a visible one. The invisible one goes from 3 to 4 sections.

I want the visible pipe at the end of section 4 to warp to section 6 but every time I playtest the level it gets rid of my warp.
Is they something that I am doing wrong!?
Can anyone please help me with this problem?

Thank you.

I have fixed it now.
Turns out what I needed to do is make the warp at the start and the end, then put the warp back in section 4 so it could work and warp the player to section 6
Thank you for your help