(SMB3+SMW+SMB1) Multi-Directional Bullet Bill Cannons

Navi · Postby **Navi** » Sat Jan 24, 2015 7:15 am

Iloveyoureggyyoumademehappy

These are nice! I'll use this.

SilverDeoxys563 · Postby **SilverDeoxys563** » Sat Jan 24, 2015 11:27 am

Eeee, I think you made the middle tube go down one pixel too far e.e

Koopris1992 · Postby **Koopris1992** » Sat Jan 24, 2015 9:11 pm

Thank you!
See you next illusion!

reghrhre · Postby **reghrhre** » Sat Jan 24, 2015 9:20 pm

SilverDeoxys563 wrote:Eeee, I think you made the middle tube go down one pixel too far e.e

Hmm, not sure what you mean, can you show a pic or something?

SilverDeoxys563 · Postby **SilverDeoxys563** » Sat Jan 24, 2015 9:42 pm

reghrhre wrote:
SilverDeoxys563 wrote:Eeee, I think you made the middle tube go down one pixel too far e.e
Hmm, not sure what you mean, can you show a pic or something?

Printscreen, good enough

Spoiler: show

only_doge.png

reghrhre · Postby **reghrhre** » Sun Jan 25, 2015 5:41 am

Bullet Bills now included

SilverDeoxys563: I think I'm just stupid, I still have no idea what you're talking about

Postby **Squishy Rex** » Sun Jan 25, 2015 5:55 am

reghrhre wrote:Bullet Bills now included

SilverDeoxys563: I think I'm just stupid, I still have no idea what you're talking about

Let me try. The bottom row of pixels in the middle section on the SMB1 Cannon shown in the printscreen is down 1 row too far. Basically in line with the rim edge, where it should be set in like the top of the cannon. I have no idea if that clears it up at all, but I tried.