Super Mario Bros. X Forums

I want to be as specific as possible on this post. So I made a level called Toad's Run, and I was planning to make it an autoscroll.
But when I tried to make it sidescroll, Toad just died when I tested the level. None of the blocks or NPCs I put in the level stayed when I tested it. When I turned off autoscroll, it worked fine. But the problem is that I want it to autoscroll. Please help! Also, I did place the player1 and player2 start above the ground.

Is the spawn at the start of the section?

Superiorstar wrote:Is the spawn at the start of the section?

Yep. But it wont work.

Try putting the barrier back, then put the position back to don't move.
after you put to do not move, put the position back to set, then move the barrier back to the destined place.
you can only have autoscroll on the default layer.

Remake your autoscroll events by putting your "Section Settings" in "Position" on "Don't Change" and once you scrolled your Level's Boundary at the place where your Players gonna Start, press "Use Current" again.