Page 1 of 1

Map Saving Errors...

Posted: Sun Jun 29, 2014 1:11 pm
by Anphiba
Today I tried using custom graphics on a world map I made. It was working smoothly, but suddenly, when I tried to save the map, SMBX crashed and it gave me an error message. I took the graphics off, and tried to save, and it worked normally again.
Can anyone tell me what happened/why I can't use custom graphics?

Re: Map Saving Errors...

Posted: Sun Jun 29, 2014 1:17 pm
by bossedit8
This error might pop uf if you caused that issue:

Image

If it is you have to take most of the custom graphics that is related to the world map out and memorize them where you put them originaly. That is sadly the only way you can do that.

Re: Map Saving Errors...

Posted: Sun Jun 29, 2014 2:51 pm
by RudeGuy
Custom sceneries beyond scene 32 cause always a run-time error. You can't fix that.

Re: Map Saving Errors...

Posted: Mon Jun 30, 2014 8:00 pm
by Anphiba
Which one is scene-32? I don't know what to do about it.

Is it only sceneries that screw it up? Or is it all the GFX?

Re: Map Saving Errors...

Posted: Tue Jul 01, 2014 6:41 am
by RudeGuy
Anphiba wrote:Which one is scene-32? I don't know what to do about it.
Watch in the graphic folder.
Anphiba wrote:Is it only sceneries that screw it up? Or is it all the GFX?
Graphics makes that error.

Re: Map Saving Errors...

Posted: Wed Jul 02, 2014 12:52 pm
by Mable
you can't replace any scenery that comes after 30.

Re: Map Saving Errors...

Posted: Wed Jul 02, 2014 12:55 pm
by Anphiba
So, anything after scenery 30, right?
Does that mean I can change tiles and levels?

Re: Map Saving Errors...

Posted: Wed Jul 02, 2014 12:59 pm
by FanofSMBX
Anphiba wrote:So, anything after scenery 30, right?
Does that mean I can change tiles and levels?
Yes.
You actually can change the scenery. Unfortunately, the changes only show up in-game.

Re: Map Saving Errors...

Posted: Wed Jul 02, 2014 1:02 pm
by Sednaiur
GrätselBüchner wrote:you can't replace any scenery that comes after 30.
No, you can replace all sceneries including scene 32. From scene 33 on, SMBX will crash, when they get replaced.

Also don't worry about any tiles / levels / paths, as you can replace them without any problem.

And about replacing the sceneries from 33 on, you can take the original scenery located in the SMBX "graphics"-folder, and make a backup-copy of them. Then replace them with the custom ones afterwards, startup SMBX then (if you do replace the original scenes while SMBX is open, it will still show the original ones, until you restart the editor), and you have all the sceneries visible.
The only drawback is, that you still see the hardcoded graphics in the scene selection.

Re: Map Saving Errors...

Posted: Wed Jul 02, 2014 1:28 pm
by Anphiba
Oh ok. Thanks, Sednaiur!!

Re: Map Saving Errors...

Posted: Sat Jul 05, 2014 10:08 pm
by Dr. Crygor
You have too much scenery
Remove some.

Re: Map Saving Errors...

Posted: Sun Jul 06, 2014 6:52 am
by RudeGuy
Dr. Crygor wrote:You have too much scenery
Remove some.
That's not the reason of the error. He can have many sceneries as he can, but the error is generated by scenes 33-last.