Super Mario Bros. X Forums

Basically, using a model swap, I managed to produce this:


Is there anyway someone can get this to work as Toad instead of Mario with Toad graphics?

P.S. Frames for when Toad rides yoshi or slides down slopes were pre-made for leaf, tanooki, and hammer Toad. The other ones have no frames of it. But using the leaf one as a base, it shouldn't be too hard. Until it gets to small Toad.

I'm not really a lunalua coder btw.

this is A Difficult Thing

Not to mention that when a yoshi egg that has a yoshi has to remain a yoshi (with the same color) instead of a green boot.

Would probably be easier to recode Mario to act as Toad vs. make Toad use Yoshis

PixelPest wrote:Would probably be easier to recode Mario to act as Toad vs. make Toad use Yoshis

Tbh, you could just rename toad's files from "toad-1" to "mario-1" Although you would need to position the frames so they aren't offcentered. I've already seen this happen with a Link retexture (replacing Link with Larry Koopa, basically the wand was part of the hitbox when facing left). Not only that, but the frames for small Toad, super Toad, fire Toad, and ice Toad, would need both frames for when sliding down slopes and riding Yoshi.

To save time, I've already had the files for "model swaps" (tbh I should just call them sprite swaps because they aren't models, they're sprites, I'm just use to seeing model swaps in Smash 4 and in Brawl): http://www.mediafire.com/file/nzphflh4h7mo5pl